Product Highlights
Operation
Tech Support & Warranty Information
Radio and TV Interference Statement
Bluetooth Portable Mini Speaker
Quick Start Guide
Listening to Music (Wired connection)
Pairing (Wireless connection)
3. After connecting successfully, the blue LED will flash
once every 3 seconds
Note: Please make sure the audio output is set to Bluetooth /
APS02F for audio streaming from the device.
If you need further assistance, please contact the Aluratek support
department for troubleshooting prior to returning this device.
WARNING!!! This equipment has been tested and found to comply with the
limits of a Class B digital device, pursuant to part 15 of the FCC rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation.
2W Adjustable
Speaker
Please make sure the device supports A2DP profile. The
pairing procedure will vary depending on the actual device.
Please refer to the user guide of your device for detail
instruction. The general pairing procedures are as follows:
1. Unwind the connector cable from around the speaker
E-mail: [email protected]
Local (Tustin, CA): 714-586-8730
Toll free: 1-866-580-1978
2. Connect any digital device with a 3.5mm audio jack
port like an iPod, iPad, iPhone, smartphones and tablets
This equipment generates, uses and can radiate radio frequency energy and,
if not installed and used in accordance with the instruction, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by whatever measures may be required to correct
the interference.
Charging the battery
1. Connect the provided USB charging cable to the mini
USB port on the speaker.
2. Connect to a USB port on your computer or laptop
3. While charging, the power indicator LED will turn red.
4. When fully charged, the power indicator will turn off.
1. Turn the switch to BT. The blue LED at the base will
start flashing.
3. Turn the speaker to LINE. The blue LED will illuminate
4. Press play from your connected device and enjoy!
Aluratek warrants this product against defect in material or workmanship
for 1 Year from the date of purchase.
3.5mm
connector
2. Activate your device’s Bluetooth function and set your
device to search for Bluetooth devices. Select APS02F
LED
For more information, please visit: http://aluratek.com/warranty-return-policy
Line, Off,
BT Switch
Mini USB port
APS02F
when it is found.
qsg Q10280 v2 Copyright © 2013 Aluratek, Inc. All Rights Reserved.
aluratek.com
|