SOLAR™
BATH
ENAMELED STEEL
BARRIER FREE
SOLAR BATH™ FOR ABOVE FLOOR
ROUGH INSTALLATION
❏ 0163.060 Right hand outlet
❏ 0165.060 Left hand outlet
Product Features:
• Acid resisting, enameled steel construction
• One-piece bath
• Integral apron
• For above-floor rough installations
• End drain outlet
• Full slip-resistant pattern
• Straight tiling flange
• Fully-bonded support pad
Nominal Dimensions:
1524 x 762 x 445mm
(60" x 30" x 17-1/2")
OPTIONAL TO FINISHED TO FINISHED
FLOOR (USALLY BETWEEN 1651 to
1981mm ( 65" & 78')
NOTE: NO CONCEALED
PIPING FURNISHED
1/2 S.P.S. OR 1/2"
C.W.T. SUPPLIES
76mm
Bathing Well Dimensions:
1346 x 610 x 337mm
(53" x 24" x 13-1/4")
SHOWER 1/2" S.P.S.
711mm
(28)
203mm
(8)
(3)
19mm
(3/4)
FINISHED
WALL
Compliance Certifications -
197mm
(7-3/4)
Meets or Exceeds the Following Specifications:
• ASME A112.19.4 for Enameled Steel Plumbing
Fixtures
C/L OF DRAIN
C/L OF SHOWER CURTAIN ROD
(USUALLY 1930mm (76")
FROM FIN. FLOOR)
FINISHED
WALL
C/L OF VALVES
102mm
1524mm
(60)
• ASTM F-462 for Slip-resistant Bathing Facilities
(44mm [1-3/4"]
(8)
DIA. HOLES)
102
(4)
365mm
(14-3/8)
SPOUT
1/2" S.P.S.
305mm
(12)
102 (4)
To Be Specified:
❏ Color:
❏ Bath Faucet*:
❏ Faucet Finish:
❏ Drain: 1583.470
FINISHED
WALL
445mm
(17-1/2)
ROUGH
FLOOR
19mm
(3/4)
762mm
(30)
DRAIN SHOE
95mm
4
PLUMBER NOTE:
PROVIDE SUITABLE FULL LENGTH
SUPPORT AT THIS POINT.
SUMP PAD
* See faucet section for additional models available
NOTES:
0165.060 LEFT HAND OUTLET (SHOWN).
0163.060 RIGHT HAND OUTLET (REVERSE DIMENSIONS).
SHOWN WITH POP-UP C.D. & O.
FITTINGS NOT INCLUDED AND MUST BE ORDERED SEPARATELY.
CONCEALED PIPING NOT INCLUDED.
IMPORTANT: Dimensions of fixtures are nominal and may vary within the range
of tolerances established by ANSI Standard A112.19.4. These measurements
are subject to change or cancellation. No responsibility is assumed for use of
superseded or voided leaflet.
MEETS THE AMERICANS WITH DISABILITIES ACT GUIDELINES
AND ANSI A117.1 REQUIREMENTS FOR ACCESSIBLE AND
USEABLE BUILDING FACILITIES-CHECK LOCAL CODES.
INSTALL WITH SEAT AT HEAD END.
H161
© 2008 AS America Inc.
Revised 2/08
|