• Drape the fly over the tent with "Eureka!" above the
door. Fit the brim rods into the grommets on the
tent wall and into the web pockets on the
underside of the fly. See fig.8.
• Repeat with a second pole onto
the opposite hub arm to form
and arch. Attach the pole clips
as you work.
See fig. 4 & 5.
Assembly Instructions for the Equinox 6:
fig.4
This is a large tent and we recommend that you have help.
With first time set-up or with windy conditions, you will need help.
fig.8
Component List:
1 Tent Body
1 Tent Bag
6 Poles
1 Pole Bag
1 Fly
2 Brim Rods
1 Stake Bag w/ Stakes
• Unpack the tent bag, pole bag and separate all of the
components. Unroll and unfold the fabric with the Eureka! label up.
Locate the hub fitting attached to the center of the roof. See fig.1.
Important: Align the hub arms to match the layout of the fabric.
fig.9
fig.5
fig.1
• Reach under the fly and locate the Velcro®
tabs. Wrap these around the tent poles to
secure the fly to the frame. Attach the
shockcorded S-hooks from the fly to the
staked rings. See fig.9.
• Lift the arch and continue attaching all remaining
poles and clips until you have a free standing
structure. See fig.6.
Your Tent is Ready for Use!
NOTE: In the event of strong wind, we recommend that
the storm rings on the fly be guyed out. See fig.10.
fig.6
fig.10.
• Assemble all of the shockcorded poles. Check
and make sure that each section is fully
seated into the next. Slide a swedged pole
section labeled "TOP " into a hub arm.
See fig.2.
• Make sure the hub and
fig.2
fabric are still aligned.
Then, insert the
proper corner ring &
fig.7
pin into the bottom
pole section.
See fig.3.
fig.3
• Move the tent to the desired
location and stake down all
corner rings. See fig.7.
REV. E 11.07
|